BP 40A and BP 60A  SET UP  MENU

 

BEC work under 3LIPO(10cell NIMh/NiCd)

5LIPO or 18 cells NIMh/NiCd MAX with BEC disabled

First, connect the motor and receiver to the speed controller

Remove battery power from the speed controller.

Turn on the transmitter.

Move throttle stick on full power position,(UP Position)

Reconnect battery power to the speed controller

After 3sec you can hear (all sound is 3times)

— CELL Type AND Number

— — BRAKE

— — — TIMING MODE

— — — — PWM

ON you need programming menu, move the throttle stick to middle position.

1 CELL Type AND Number

•— NiMh/Nicd AUTO0.8V/CELL*

•— — 3LIPO 2.75V/CELL

•— — — 4LIPO2.75V/CELL

•— — — — 5LIPO2.75V/CELL

*IF used 2LIPO you can use the option .(select the NiMh/Nicd AUTO)

2 BRAKE

••— NO

••— — SOFT

••— — — MID

••— — — HARD

3 TIMING MODE

•••— 2 º

•••— — 7 º

•••— — — 15º

•••— — — — 30º

4 PWM

••••— 8KHZ

••••— — 16KHZ

••••— — — 32KHZ

IF the option is you need ,then move the throttle stick to UP position.

The long BEEP is save the option. and the system will go to the programming menu.

You can setup other options.

When all you need option is setup OK, push the throttle stick to down position, after 1sec the

system were save all option,  you can start the motor now!!